!!! NEW !!!
the firmest slat on the market
The S-90 external blind with guiding in guiding rails enables the smooth regulation of light intensity in the interior and at the same time shading up to 85% of the sun’s radiation, and thus preventing the interior overheating. The S-shape, 90 mm wide slat with rolled sealing ensures noise-free operation of the blind, and moreover it is able to pretty darken interiors. The external blind with S-slats is is the most firmest type of external blinds.
Advantages of external blinds S-90
- external blind with the best shading results
- smart shape of slat similar to roller blinds and doors
- noise-free operation of the blind
- high resistance of slat against damage by strong wind
- 19 colour shades on stock
The advantages of external blinds Z-90 and C-80 are combined in the new external blind S-90. The new type of external blind S-90 achieves excelent shading results. When the slats S-90 are completely closed, then the shading result is the same as by external blind Z-90. The slats are provided with rubber insulation to avoid any noise of slats in the wind.
Its new rounded shape of slat resembles the slat C-80, which is very popular among architects because of its elegant shape.
The new S-shaped slats fit perfectly to the roller blinds not only if the S-shaped slats are in closed position. This character will be appreciated especially by ťhose, who intend to install on the building external blinds, roller blinds and doors at the same time.
The blind is controlled by a crank handle or electric motor. Greater convenience can be achieved by connecting to automatic sun/wind controls.
Basic technical parameters:
| Maximum width of blind: | 400 cm |
| Maximum height of blind: | 400 cm |
| Maximum width of connected blinds: | 8 bm (electric control) |
| Type of blind | Min. width of blind | Max. surface of blind |
| S-90 operation by crank handle | 40 cm | 9 m2 |
| S-90 operation by motor | 60 cm (55) | 14 m2 |
Connecting blinds:
It is possible to connect more blinds to one control. However, if the motor is placed in the middle of the assembly there, is a maximum of 3 blinds to one control. The additional rule that there may be at most 5 bearings (revolving mechanisms) on each side of the motor must also be observed.
Material of blinds:
slats - aluminium, two-sided, colour-adjusted, rolled into a S-shape with rolled sealing profile, width of slats: 90 mm
upper part - 56 x 58 mm of zinc-coated steel plate or extruded aluminium, in any colour according to the RAL colour swatch or in elox
lower part – extruded aluminium across width of slats, in any colour according to the RAL colour swatch or in elox
guiding parts – 20 x 20 mm of extruded aluminium, in any colour according to the RAL colour swatch or in elox
cover plate – bent 1,5 mm or 2 mm thick aluminium plate, in any colour according to the RAL colour swatch or in elox
fabric supports and strips – special synthetic fibres, grey or black
